LED lightbar 1200mm, orange, 12-24V, ECE R65, controller with control of selected mode :: Warning lights for cars

LED lightbar 1200mm, orange, 12-24V, ECE R65, controller with control of selected mode

Add to favourites Add to compare list

LED lightbar 1200mm, orange, 12-24V, ECE R65, controller with control of selected mode

Bory AutoLight
Product code: sre1-1200con1
470,90 Eur incl. VAT
In stock! (11 pcs) - Products in stock ordered up to 12PM are usually shipped the next working day!
Bory AutoLight
Product code: sre1-1200con1

The orange LED light bar with a smoke cover is suitable for all types of vehicles due to its dimensions.

It is designed for vehicles where special emphasis is placed on the warning effect.

The bar is equipped with an additional controller for more comfortable control of the bar with feedback control of the selected mode.

Technical parameters:

• supply voltage 12-24 V

• light source: 95W ​​(432 LED)

• aluminum casing with polycarbonate smoke cover

• special parabolas for a strong warning effect

• 19 variants of warning flashing modes

• possibility of reducing the luminosity

• ECE R10, R65 homologation

• dimensions: 1200.5 x 259.3 x 36 mm

• working temperature: -45 °C - +60 °C

• waterproof IP67

• connection: 3m cable terminated with power wires

Color Orange
Certification ECE R10 covers the approval of vehicles and electrical/electronic equipment with regard to electromagnetic compatibility (EMC). It sets requirements so in-vehicle devices limit electromagnetic emissions and have adequate immunity to interference. EHK R65 TA1 denotes a Category T (360°) beacon, A = amber, in Class 1 (one standard intensity level).
Protection rating The product is dust-tight (no dust ingress) and resistant to temporary immersion (short-term immersion; typically up to 1 m for a limited time).
Voltage 12/24V
Connection type Connection and control via an external control box. Enables switching modes, intensity or flash patterns depending on the device.
Mounting type Screw mount – a stable installation using screws (typically through a base plate or mounting holes). Best where the beacon is intended to stay permanently installed.
Length 1200 mm
Height 36 mm
Width 259 mm
Before using the device, carefully read the instructions and follow the warnings, safety information, and recommendations to prevent injury or damage. If possible, test the product and its functionality before installation. Perform the installation with the power disconnected and observe the correct polarity. Check the correct voltage (12/24 V) and use the appropriate fuse. Do not use damaged cables, connectors, or devices. Ensure that the cables are securely fastened and routed away from sharp edges and hot parts of the engine. The lights can be very intense and hot: do not look directly into the light source and do not touch it immediately after operation. Keep out of reach of children and protect from water unless the product is specifically designed for outdoor use. When using on public roads, familiarize yourself with and comply with local regulations. Use the product only for its intended purpose.
Manufacturer's representative in the EU PNI
Address of representative in the EU Olteniei 26A, Piatra Neamt, Romania
EU representative email contact@pni.ro

Alternative products3

%s ...
%s
%image %title %code %s
%s