LED additional directional lights 12-24V, 608mm, ECE R65 :: Warning lights for cars

LED additional directional lights 12-24V, 608mm, ECE R65

Add to favourites Add to compare list

LED additional directional lights 12-24V, 608mm, ECE R65

PRC
Product code: br-traffic608
337,30 Eur incl. VAT
In stock! (11 set) - Products in stock ordered up to 12PM are usually shipped the next working day!
PRC
Product code: br-traffic608

The directional amber LED additional lights (arrows) are intended for e.g. marking a stationary vehicle or when working on the road.

They are also suitable for use e.g. when marking various objects obstructing traffic when working on the road.

High quality design with high resistance to moisture, dust and vibration.

 

Technical parameters:

- supply voltage 10 - 30 V

- light source: 96 x LED 1W

- 12 flashing modes (including left, right, sideways)

- ECE R10, ECE R65, CLASS2 approval

- current consumption: 5.4 A/12 V - 2.7 A/24 V

- Material: aluminium/plastic lens

- dimensions: 608.2 x 480 x 47 mm (each light)

- Power cable length 500 mm

- cable length to remote control 3800 mm

- working temperature -45 - +60 ºC

- waterproof IP67

- weight approx. 6 kg

Color Orange
Certification ECE R10 covers the approval of vehicles and electrical/electronic equipment with regard to electromagnetic compatibility (EMC). It sets requirements so in-vehicle devices limit electromagnetic emissions and have adequate immunity to interference. EHK R65 TA1 denotes a Category T (360°) beacon, A = amber, in Class 1 (one standard intensity level). EHK R65 TA2 denotes a Category T (360°) beacon, A = amber, in Class 2 (two intensity levels including a reduced night mode).
Protection rating The product is dust-tight (no dust ingress) and resistant to temporary immersion (short-term immersion; typically up to 1 m for a limited time).
Voltage 10-30V
Connection type Connection using loose wires. Suitable for connection via your own switches or connection to assemblies.
Length 610 mm
Height 480 mm
Width 47 mm
Before using the device, carefully read the instructions and follow the warnings, safety information, and recommendations to prevent injury or damage. If possible, test the product and its functionality before installation. Perform the installation with the power disconnected and observe the correct polarity. Check the correct voltage (12/24 V) and use the appropriate fuse. Do not use damaged cables, connectors, or devices. Ensure that the cables are securely fastened and routed away from sharp edges and hot parts of the engine. The lights can be very intense and hot: do not look directly into the light source and do not touch it immediately after operation. Keep out of reach of children and protect from water unless the product is specifically designed for outdoor use. When using on public roads, familiarize yourself with and comply with local regulations. Use the product only for its intended purpose.
Manufacturer's representative in the EU STUALARM IMPORT, s.r.o
Address of representative in the EU Na Křivce 1082/30, 10100 Praha 10 - Vršovice
EU representative email info@stualarm.cz

Alternative products2

%s ...
%s
%image %title %code %s
%s