Onboard DISPLAY 3.5" LCD, GPS speedometer with built-in multi-axis gyro and suction cup
On-board display (computer), displays speed, engine speed, vehicle tilt and other data on a clear colour LCD display while driving.
The display connects only to the OBD diagnostic connector and reads all the data itself from the vehicle's data bus or can be switched to the GPS system and finds the exact speed itself according to the GPS signal.
The on-board display can be mounted either using a bracket and double-sided cardboard on the dashboard or using a bracket with suction cup on the windscreen.
Features:
- Automatic adaptation to the vehicle model, information is read from the on-board computer via OBD II or EUOBD connector
- LCD display, colour with high resolution
- 11 graphic display options
- Multi-colour display makes the screen more readable
- Display shows: speed, engine speed, water temperature, oil temperature, battery voltage, fuel consumption (current/100 km), odometer, turbo pressure, intake air temperature, vehicle tilt
- low battery voltage warning, high engine speed/revs, high engine temperature
- switching between kilometre and mile modes and Celsius/ Fahrenheit temperature degrees
- diagnostics and deletion of engine fault codes
- measurement of vehicle acceleration and deceleration during braking
- automatic on/off when the engine starts and stops - effective protection for the car battery. Manual switch mode is retained with this function
- automatic brightness adjustment mode for glare-free driving
Technical parameters
- Supply voltage: 12 V (10-18 V)
- 11 x display mode
- Standby power less than 15 mA
- Operating power max 200 mA
- Compatibility with all vehicles with OBD2 and EUOBD
- Units: km / miles
- dimensions: 102 x 70 x 24 mm
- Operating temperature: -20-75℃
Notice
Due to possible incompatibility with some vehicle models, we recommend testing with the vehicle first and then installing firmly in place. Due to compatibility with most cars, not all features of the device may be available on some models
Recommendation: when installing the device in a vehicle for the first time, we recommend that you reset the on-board computer to factory settings so that the data is loaded correctly, this recommendation also applies when installing it in another vehicle.